Over time, the doors in your house may be starting to become sticky and cramped. Make you uncomfortable every time you open or close. To solve this problem, sometimes just tighten the hinge screws, but sometimes the door size needs to be changed. One of the best ways to change the size of a wooden door is to flatten the edges of the doors to reduce door binding.
So how to plan a door without removing it? That thought impossible, but it could be done. You only need to determine the area that needs to be planned, remove wood by the best wood planer gradually and check your work as you go. With a little care and proper technique, you can make your door work smoothly again.
In particular, you can use all types of the best wood planer but I think using a hand planer is best suited, I do not take much of your time anymore. Let’s get started.
Step 1: Start by opening and closing the door a few times so you can locate where it is rubbing or sticking. Place a piece of cardboard or folded paper between the door and the jamb to determine the starting and ending points for the area to be planned. Use a pencil to mark this area on the side of the door, not on the edge.
Step 2: Use your ruler to measure from the jamb to the start and endpoints on the door about 1/8 inches. Draw a line between the start and endpoints with your ruler. Although this may be just a short length, it is important to be able to see the correct width. If you want to plan a larger area, use a carpenter’s compass to mark your route.
Step 3: Use a door stopper to keep the door still. That prevents the door planing process from wobbling, making the planning process stable and not dangerous to the planer anymore. If you find that the door is still wobbling, use the second door on the other side of the door.
Step 4: If you want to plan on an upright edge, scrape off with wood grain. If you want to work on a horizontal edge, start on the outer edges and work towards the center gradually. Make sure you apply a solid but gentle pressure on your planer so you don’t shave too much or make marks on the wood surface. Remember: unlike hair, the removed wood cannot grow back. Therefore, it is better to plan many times and thinly instead of once to avoid excessive shaving.
If you need to remove more than 1/8 inch of wood from the door, you may need to use sanding tools or the best thickness planer. And remember, To work will be simpler and faster, You need less control. Move carefully and slowly when using power tools so you don’t create any holes or dots.
Step 5: After planing, open and close it a few times to check. If you find it still sticky, shave a little more. Keep opening and closing doors and shaving until it is no longer sticky. Now it’s time to polish the part you have planned, then mark it and finally repaint it (remember to be the same color as the other parts of the door). Let the door dry for 1 hour and make sure you place a door block in place so that the door doesn’t accidentally close while it’s dry.
Have you found that shaving your door without taking it out of the frame is much more convenient and time-saving? However, not every door position you can plan directly. If you need to work at the bottom of the door, you’ll need to remove the door from the hinge to access the bottom.
Finally, there may be a few errors in this article, I hope you can ignore them. And thank you for taking the time to read the article.